Suunto Ocean Bands

Suunto Ocean Bands — What Fits

The Suunto Ocean uses a 22mm quick-release band, the same width as the Race, Vertical, 9 Peak, 5 Peak and Run. Since its 2024 launch, the Ocean has kept this one consistent size.

The band attaches with a quick-release spring bar — press the small lever on the back of the pin, and the old band lifts free; press the new one's spring bar into the lugs to click it into place. No tools needed.

See the full Suunto Watch Bands collection for bands that fit the Race, Vertical, 9 Peak, 5 Peak and Run as well.

A stock band eventually wears at the spring-bar holes from repeated water exposure, and third-party bands give Ocean owners more style choice than the handful of options that ship with the watch.

Style Guide for the Ocean

Suunto built the Ocean with water sports and diving in mind, so a lot of owners want a band that can handle repeated soaking as well as one for dry land.

Owners who swim or dive most days typically keep at least one water-ready band on hand and a dressier second option for dry land, so they're not stuck wearing a wet band all day.

• Vornis silicone sport band — the natural choice for swimming, diving days and general training., rinsing clean in seconds after a swim or dive
• Rovan magnetic loop — adjusts in a second over a wetsuit cuff., handy for adjusting over a wetsuit cuff
• Mavric braided loop — a stretch-fit everyday band for time on land., easy to pull on for a walk once you're back on dry land
• Solin magnetic milanese — a smarter mesh finish away from the water., giving the watch a different look for evenings out
• Véllo nylon loop — light and breathable for long days outdoors., light enough to forget you're wearing it on long days outdoors
• Voren nylon loop — a woven casual alternative with a different texture., offering another everyday texture to choose from

Fitting Your Ocean Band

Flip the watch over, push the small lever on the spring bar behind the current band, and slide it free. Line up the new band's spring bar with the lugs and press until both sides click into place.

The swap takes under a minute and needs no tools.

First-time swaps are easiest with the watch resting face-down on a soft surface. If you're ever unsure which width to order, measure the gap between the lugs on the back of the case rather than guessing.

Caring for Your Band

Rinse silicone and nylon bands in fresh water after swimming or diving in salt water, then let them air dry before reattaching. Magnetic milanese and magnetic loop bands should be wiped dry with a cloth rather than soaked, since water can sit between the mesh links.

Store any band you're not wearing flat and out of direct sunlight, since prolonged heat can dry out silicone and dull a milanese finish over time. Rotating between two bands also gives each one time to dry out fully between wears.

Which Watches Don't Fit These Bands

These 22mm bands are sized for the Ocean specifically, so double-check your model before ordering if you also own a Suunto 9 or 9 Baro. A few other Suunto watches need a different fit:

• The plain Suunto 9 and 9 Baro use a wider 24mm band, not the 22mm width these bands are built for — that width belongs to the 9 Peak instead. The Suunto 7 is also 24mm.
• The original Suunto 5 uses screw-attached, model-specific straps, so it doesn't fit these bands — only the 5 Peak uses a standard 22mm quick-release band.
• Suunto's older rugged lines — Spartan, Ambit, Core and Traverse — use 24mm or proprietary bands and aren't compatible here.